lima live view
Need a command on lima detector to set them in live mode and have a live display of images. This is used on a couple of beamlines during sample alignment phase for example. What would be needed:
-
mycamera.live_start(expotime)
: start live mode with given exposure time or last expo time set if not specified. This command should also disablemycamera
from active measurement group to not have it in nextct
/scans
-
mycamera.live_stop()
: stop live mode and eventually activate backmycamera
in active MG if it was active before live starts. -
mycamera.live_status()
or.live_state()
: should display live mode status and exposure time used
From lima point of view, commands to do that are easy. But I do not know how to deal with live display. Shall we go with LiveImagePlot
as @pguillou did with EBV bpms ?? Need some advice !!
Edited by Cyril Guilloud